Janwien 8 Pieces PS5 Controllers, PS5 Game Controller Controller 3D Joystick Sensor Module, Replacement Game Controller, Analog Joystick Controller, for Xbox One Replacement (Green) Fiche Technique et Prix au Maroc

Characteristics: There are two different resistance values. Make sure the value is about 2.3K before ordering. The complicated movement mechanism and daily wear and tear finally caused a drift. Even the new sensors cannot be 100% balanced. Calibration in controller settings may not work. Solder one or two tiny resistors in parallel on the potentiometer in the opposite direction against the drift. This will help correct the drift by 3-5 degrees. Pay attention: Choose 10KΩ version for most PS3, PS4, Xbox One, Elite Series 1 and 2, Xbox Series S|X and Switch Pro controllers. Specifications: Product name: PS5 joystick potentiometer Product size: 10.5 x 9.5 cm Color: Green Material: Metal, Plastic Package included: 8 x PS5 controller potentiometer Notes: There may be deviations due to manual measurement.
[PS5 Parts] OEM Repair Parts Made by ALPS – The same manufacturer as your PS5 Wireless Controller. The original replacement set is intended to ensure accuracy and extend the service life.
[2.3KΩ Potentiometer] It fits ALPS analog joysticks. This potentiometer resistor works with PS5 DualSense and some PlayStation 4 DualShock 4 wireless controllers with a 2.3K ohm ALPS controller module inside.
[Easy to Install] PS5 potentiometers are very easy to install these trimmer potentiometer sensors. All you need is an electronic soldering iron and a small gauge solder, and you can complete the replacement of the potentiometer. Remember to clean the old holes before re-soldering the new sensor on the trimmer potentiometer.
[For Most Joystick Problems] The potentiometer sensor needs to be replaced when the controller has the problem of crawling, stuttering, blind spot, dead spot, dead zone, or it would not center after years of wear. Desoldering the unit with only 3 pins will be much easier than replacing the assembly of the 14-pin joystick.
[Compatibility] Excellent controller replacements and joint repair parts for analog joystick. Please choose 10K ohm for most PS3, PS4 DualShock 4, Elite Series 1 and 2, Switch Pro controller.